Yes:

• Panel with an access opening of at least 1/4 of an inch
• Dent location within tool reach
• Panel with no factory access but can be drilled (All drilled openings are hidden or covered to prevent leak and rust)
• Just about anything that is not under the list below

No:

• Damage that is less than 2-3 inches away from any of the edges
• Panel with no open access and cannot be drilled
• Panel has been repainted by a body shop
• Panel was repaired with BONDO
• Panel is not metal
• Any of the pillars (It can be done by drilling but we do not recommend it due to structural integrity)
• Paint that is cracked or chipped (dent could be removed but not the paint)
• Out of tool reach
• Convertible rear quarter panel (some can be done but limited)
• Roof with sun/moon roof (please check for exceptions)